NSTALLING FLOWCORD ONTO CORD CONNECTORS
- Melt the end of the flowcord (to prevent fraying). Push and twist the cord to help thread it through the connector.
- Slide a washer onto the end of the flowcord (you can use pliers to help pull it through).
Note: Flowcord needs a washer to secure leash to connector. Phatty cord does not require washer.
Tie a simple overhand knot below the washer – don’t tighten it yet! Check and confirm how long you’d like your leashes to be.
- Once you find your ideal length, tighten the knot, and trim off excess cord with a pair of scissors, leaving 1/8” or 3mm extra to melt.
- Using a small flame, melt the end of the cord until it reaches the surface of the knot and use a flat metal surface to press the melted end into the sides of the knot, fusing it together and ensuring it cannot come undone! (the side of a lighter works great :)
- Snug the washer up against the knot.
- Insert the cord connector into the tube - make sure to line the connector screw holes up with the holes in the tube
- Screw in the cord connector using the hex key provided, making sure the screws end up flush with the tube.